Commissioning - Bosch Deepfield Connect Originalbetriebsanleitung

12 | English
Technical data
Sensor rod
Number of temperature sensors
Measuring depths
Measuring range
Measurement accuracy
in the range –10...+85 °C
Resolution
Weight
Permitted ambient temperature
for operation and storage
Dimensions
Cable length
Transmitter
Cellular network
Localization
Battery
Battery voltage
Battery self-discharge
Weight
Storage temperature
Permitted relative air humidity for
storage
Permitted ambient temperature
for operation
Dimensions
Protection category
Deepfield Asparagus Monitoring app
Hardware requirements
Operating system

Commissioning

Installing the app on a mobile device
Install the Deepfield Asparagus Monitoring app from the
Google Play Store or the Apple App Store. To do so, follow the
instructions provided by your operating system.
Starting the app and logging in
You will have entered your e-mail address and a password
when you ordered a monitoring station from the Deepfield
Connect online shop. You can use this information to log into
the app.
Alternatively, you can register again. Deepfield Connect must
be able to contact you via the e-mail address that you provide
when registering.
Asparagus Monitoring | (10.1.18)
4
0, 5, 20, 40 cm
–55...+125 °C
±0.5 °C
0.0625 °C
0,4 kg
–40...+45 °C
445  72  66 mm
2.5 m
GSM, D2 Vodafone
GPS
– Alkaline manganese
– Not rechargeable
4.5 V
4 % per year
0,9 kg
+5...+40 °C
30...70 %
–20...+50 °C
200  112  80 mm
IP 67
Mobile device
(tablet, smartphone)
– Android 4.1
(and later)
– iOS 9.0 (and later)
 Start the app.
 Select "log in".
 Enter your login data or select "register".
If you are registering again, you will be shown the criteria for
creating a secure password.
App functions
The app provides the following functions:
– Field overview: Displays the measured values and weather
forecast for the fields. Plan agricultural film use on the
basis of this information, with optional notification of em-
ployees.
– Alarm overview: Displays the limit values set and any limit
values that have been exceeded. Set limit values.
– Temperature sums: Displays temperature sum values. Set
target values (harvest indicator).
– Field management: Add fields. Register monitoring station
and assign fields. Displays battery status and signal quali-
ty. Transmitter search help.
– Share data: Allow other users read-only access to separate
fields.
– Settings: Turn alarm signals on and off. Display license and
version information. Contact Deepfield Connect.
The main menu can be opened by swiping a finger from the
left edge to the right edge of the screen. The main menu can
also be reached from each submenu by pressing the menu
symbol .
Inserting the battery
Also see figure 2 on page 2.
NOTE
 Risk of damage!
Penetrating water or chemicals may damage or
destroy the monitoring station. Only insert the battery
in a clean and dry environment.
 Open the battery compartment.
 Insert the battery connector into the socket.
 Place the battery and the cable in the transmitter. The
cable should be underneath the battery if possible (see
figure 2, page 2).
 Close the battery compartment cover and lock it carefully
with the two screws.
Switching on the transmitter and registering the
monitoring station
You have to switch on and register the transmitter before the
system can function. You should complete both of these steps
before installing the monitoring station in the field.
The magnet supplied is required to switch the device on. The
status LED displays the progress.
 Hold the magnet against the recess on the transmitter (see
figure 1, page 2).
Robert Bosch Start-up GmbH, Deepfield Connect