Operating - Westfalia Laser 2000 FS-3001 Bedienungsanleitung

2. Fit the floor cloth (8) around the base. Make sure the
floor cloth the padded edges are secured. The floor
cloth is made of 100% cotton and can be used both-
way. Never use the floor steam cleaner without floor
cloth!
3. Connect the power plug with a grounded wall socket. The power indicator
light (3) turns on. The floor steam cleaner needs approx. 4 minutes to trans-
form the water to steam.
4. Unscrew the telescopic tube (6) with the threaded side in the handle (7). Pull
the telescopic tube out and secure it in the desired length.
5. Press the ON/OFF switch. If steam turns out the appliance is ready for use.

Operating

Before cleaning the floor we recommend to text the floor steam cleaner on a
hidden place.
1. Only press the ON/OFF Switch (5) with your foot
down. On lightly soiled surfaces begin cleaning by
slowly passing the floor steam cleaner back and forth.
On heavy soiled places leave the floor steam cleaner
over the spot for a minimum of 8 seconds, but not
more than 15 seconds.
Do not let the floor steam cleaner during operation to stand on any place for
extended period of time long time. Hot steam could damage wood floor.
2. To avoid passing over the cord and for trouble-free cleaning, hang up the
cord on the hook, situated on the upper part of the telescopic tube (6).
3. With the built-in ball joint (7) you can easily tilt the telescopic tube to the
intended angle or lock the tube upright.
4. While cleaning, observe the refill indicator light (4). With one thankful you can
clean approx. up to 15 minutes.
Setting up the Appliance
12