Grundig Sinio DTR 6110 S Bedienungsanleitung Seite 19

Sinio DTR 6110 S / 6111 S CI
Main Menu
1 Service Table
2 Search
3 System Setup
4 Timer
5 Over-Air Download
6 CI Setup
System Setup
1 LNB Settings
2 AV Setup
3 Favourites
4 Language, Time
5 Information
6 Password Set
7 Factory Settings
66
GRUNDIG Service
IMPORTANT INFORMATION
Updating the satellite receiver's software
The future-oriented digital technology of this satellite receiver enables updating
of the receiver's operating software via the ASTRA satellite.
The » Information« menu informs you whether a new operating software is
available
Condition for the software download is that the satellite receiver is directed at
the satellite Astra 19.2° East.
Select a service of the Astra satellite.
1
Call up the »Main Menu« on the picture screen using the »
2
Select the » Over-Air Download« row using the
3
confirm with »OK«.
– A dialogue box appears on the picture screen.
4 Select the »Yes« option using the
»OK«.
– The picture screen of the TV set and the display on the front side of the
satellite receiver are blanked (dark screen).
Exit
– Following that, the message »
display. Please wait.
Note:
The satellite receiver compares principally its own operating software with
the software offered by the Astra satellite and decides whether a download
is necessary.
This can take a few minutes.
If no new software version is available, the message
appears on the picture screen, and then the last selected channel again.
Please read also the following page!
IMPORTANT INFORMATION
Important!
If the action takes several minutes, a new operating software is being
loaded. Please wait.
When downloading is completed, the indication »
satellite receiver's display, and then the following message on the picture
screen:
Your satellite receiver then is programmed with the current operating software.
The last selected satellite service appears again on the picture screen.
– The new software version is shown in the »Information« menu.
Resetting the satellite receiver to the factory settings
You can restore the factory settings and reset all changed settings.
1 Call up the »Main Menu« on the picture screen using the »
2 Select the »System Setup« row using the
Please enter Password
confirm with »OK«.
* * * *
Select the »Factory Settings« row using the
3
with »OK«.
– The » Please enter Password« text box appears on the picture screen.
Exit Back
4 Enter your password as 4 digits using the
___________________________________________________
»P+, P-
»P+, P- « buttons then confirm with
boot « appears in the satellite receiver's
*****Update Not Necessary*****
___________________________________________________
oooo
« appears in the
*****Update Completed*****
»P+, P- « buttons then
»P+, P- « buttons then confirm
»1 ... 0 « buttons.
Allgemeiner Teil / General Section
« button.
Menu
« buttons then
65
« button.
Menu
1 - 19