IKEA DJUPFRYSA Bedienungsanleitung Seite 15

ENGLISH
Problem
The compressor does not
start immediately after
pressing Fast Freezing, or
after the change of the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Door does not open easily.
If your appliance is still not
working properly after making
the above checks, contact the
Authorised Service Centre. You
can find the list at the end of this
manual.
Closing the door
1. Clean the door gaskets.
Possible cause
This is normal, no error has
occurred.
The Fast Freezing function
is switched on.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened too often.
The Fast Freezing function
is switched on.
There is no cold air circula-
tion in the appliance.
You attempted to re-open
the door immediately after
closing.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
The compressor starts after
some time.
Switch off Fast Freezing func-
tion manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Fast Freezing function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
Make sure that there is cold
air circulation in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
assembly instructions.
gaskets. Contact the Authorised Service
Centre.
15
Solution