Inhaltsverzeichnis
Werbung
Before first Use
Remove the screwdriver and all accessories out of the packaging.
Check all parts for damage in transit and do not use damaged accessory
or a damaged tool. Keep packaging materials out of reach of children.
There is risk of suffocation!
Intended Use
The screwdriver is intended for driving in and loosening screws in wood, metal,
ceramic and plastics.
Charging the Battery
1. Before the first use, charge the battery of the screwdriver for approx.
8 hours. For later charges 3 – 4 hours are sufficient.
2. Connect the screwdriver to the charger (8). The charging socket (7) is
located in the rear part of the housing. After that, connect the charger to a
wall outlet.
3. Please confirm that your local mains voltage corresponds to the operating
voltage stated on the type label. During charging, the red control LED (6)
located next to the charging socket, lights up.
Batteries do not belong in household
garbage.
For battery disposal, please check with your
local council.
Inserting the Tool Bits
1. The screwdriver is equipped with a keyless chuck (3). Please do not insert
the bits (1) directly into the chuck, please always use the magnetic bit
holder (2) or the ¼'' square connector.
2. When selecting a bit, please make sure the bit fits the screw. Insufficient
power transfer can lead to the destruction of both bit and screw.
Operation
6
Werbung
Inhaltsverzeichnis
