Bosch PPW2360 Gebrauchsanweisung Seite 15

en
Measuring your weight
and starting an analysis
To measure your weight as well as your BMI
and the percentages of body fat, body water,
muscle mass and bone mass (Figure E).
Caution:
Pregnant women and persons with implanted
devices such as pacemakers must not use
these scales.
Important:
The scales automatically calibrate when
switched off.
To ensure a correct reading, do not move
the scales after switching off.
The scales automatically identify the users
based on their weight (deviations of +/– 5%
possible). You do not need to turn it on. Just
step on the scales with bare feet and stand
still while the display flickers. Distribute your
weight evenly between both legs.
Four different situations can occur as
described here (user detection) with the
measured values display.
The user was identified
The display shows the weight and the User
Profile Number (in the top left corner). After
about 5 seconds, the
Press the right navigation button ► to
display the results of the analysis
The scales display each of the following
values for about 2 seconds:
E
: Body fat in %
M
: Body water in %
N
: Muscle mass in %
O
: Bone mass in %
J
: Weight in kg
These values are automatically repeated
twice.
At the same time, the illuminated segment
lights up:
I
appears.
Q .
Green – The values are within the normal
range
Orange – The values are not within the
normal range
The scales always compare the latest
readings with the stored averages of the
most recent 5 measurements. The arrow in
the top right corner of the display indicates
whether the trend of these values is upward
S or downward R
The bar scale on the right additionally
indicates the classification:
The exact values for these classifications are
shown in the tables on the foldout pages at
the end of these operating instructions.
The scales switch off automatically a few
seconds after completing the measurement
process.
The user was not identified correctly
The scales display only the weight and the
I
.
The top left corner of the display shows a
question mark ? .
The indicated User Profile is your own:
● Press the right navigation button ► to
display the results of the analysis.
or
The indicated User Profile is not your own
● Press the left navigation button ◄; the
scales display the current User Profile
H
.
● Press the SET button.
● Use the navigation buttons ◄ ► to select
your own User Profile and confirm your
personal data with the SET button or
enter the values as described in "Entering
your personal data".
.
– Upper range
+ Normal range
++ O ptimum range
+ Normal range
– Lower range
PPW2360 01/2011
11