Bosch GPL 3 Professional Originalbetriebsanleitung Seite 12

OBJ_BUCH-807-002.book Page 12 Tuesday, September 30, 2008 1:13 PM
12 | English
Technical Data
Point Laser
Article number
Working range
Levelling Accuracy
Self-levelling range
(typical) alongside the
– longitudinal axis
– lateral axis
Levelling duration,
typically
Operating temperature
Storage temperature
Relative air humidity, max.
Laser class
Laser type
Tripod mount
Batteries
Operating life time,
approx.
Weight according to
EPTA-Procedure 01/2003
Dimensions
Degree of protection
Please observe the article number on the type plate of
your measuring tool. The trade names of the individual
measuring tools may vary.
The measuring tool can be clearly identified with the
serial number 7 on the type plate.
Product Features
The numbering of the product features shown
refers to the illustration of the measuring tool
on the graphic page.
1 Exit opening for laser beam
2 Latch of battery lid
3 Battery lid
4 On/Off switch
5 Laser warning label
1 609 929 S08 | (30.9.08)
6 Tripod mount 1/4"
7 Serial number
GPL 3 8 Holder
Professional
9 Locking screw for holding device
3 601 K66 1..
10 Screw holes of holder
11 Opening for strap attachment
30 m
12 Magnets
± 0.3 mm/m
13 1/4" tripod mount on holder
14 5/8" tripod mount on holder
15 Measurement plate with stand*
± 5°
± 3°
16 Protective case
17 Laser viewing glasses*
<4 s
18 Tripod*
– 10 °C ... +50 °C
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
– 20 °C ... +70 °C
overview of accessories can be found in our acces-
90 %
sories program.
2
635 nm, <1 mW
Assembly
1/4"
3 x 1.5 V LR6 (AA)
Inserting/Replacing the Battery
Alkali-manganese batteries are recommended
24 h
for the measuring tool.
To open the battery compartment 3, turn the
0.25 kg
latch 2 in clockwise direction to position
pull off the battery lid. Insert the batteries pro-
104 x 80 x 40 mm
vided. When inserting, pay attention to the cor-
IP 5X
rect polarity according to the representation on
the inside of the battery compartment.
Position the battery lid to the bottom of the
housing and then push it upward. To lock the
battery lid, turn the latch 2 in anticlockwise
direction to the
When the laser beams flash slowly during oper-
ation, the batteries are low. When the flashing
begins, the measuring tool can be operated for
approx. 8 h.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the bat-
teries can corrode and discharge themselves.
and
position.
Bosch Power Tools