Kärcher K 5.79 MD Bedienungsanleitung Seite 14

Description of the Appliance
Illustrations on Page 2
1 Power cable with plug
2 Storage for spray lance
3 Transport handle
4 Suction hose for detergent
5 Dosage regulator for detergent
6 Storage for trigger gun
7 Detergent Tank
8 ON/OFF switch for appliance
9 High pressure connection
10 Connection for water supply with filter
11 Coupling element for water connection
12 Trigger gun
13 Lock trigger gun
14 Key to detach the high pressure hose
from the trigger gun
15 High pressure hose
16 Spray lance with pressure regulation
(Vario Power)
17 Spray lance with Dirtblaster
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Before Startup
Illustration
Mount loose parts delivered with appliance
prior to start-up.
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.
Water supply
Warning
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
14
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Screw the supplied coupling element to
the water connection on the appliance.
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
 Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Completely open the water tap.
 Insert the mains plug into the socket.
 Turn on the appliance "I/ON".
– 4
EN
Start up