Werbung
ME CD 60e
^ BLAUPUNKT
Basic Operation
Power
You can use all the functions on the panel of the unit or the remote control after
connecting to a power supply (called Standby Mode).
Tuming the System On
Press the © button to turn the system on from standby mode.
Note: When turning the system on, the system will continue in the mode it was in when it
was previously turned off.
Tuming the System Off
Press the button again to turn the system off and go to standby mode.
Note: Be sure to unplug the power cord from the outlet when the system is not in use for
an extended period of time.
Settingthe Clock
The built-in clock shows the correct time onthe display.
1.In standby mode, press and hold the CLOCK button to activate the clock setting mode,
hour indicator will blink.
2.Setthe hour with the А button or Y button.
3. Press the ENTER or CLOCK button to confirm, minute indicator will blink.
4. Set the minutes with the A button or "button.
5. Press the ENTER or CLOCK button to confirm, the built-in clock starts operating and the
seconds start counting from 0.
Note:
*
The operating time of every step should not take longer than 15 seconds or it will
return to the original display.
=
If there is a power failure or the power system is turned off, the clock will lose its
setting.
To confirm the clock time
When you press the CLOCK button, the clock time is displayed. Wait for a few seconds for
the display to return to the ori
gi nal display.
I
2
-
Ы
=
ш
Adjust volume level
During play, press the VOL+/- buttons to increase /decrease the volume level.
Selecta preset sound effect
During play, press the EQ button repeatedly to select:
[FLAT] [Pop] [Classic] [Rock] [Jazz]
Bass
Selecta preset sound effect: Bass 1, Bass 2, Bass 3.
Mute sound
During play, press the MUTE button to mute or restore sound. Press this button again or
press VOL« button to cancel the effect.
Adjust brightness of display panel
Press the DIM button repeatedly to select different levels of brightness for the display
panel.
68
Werbung
