Werbung
Verfügbare Sprachen
Verfügbare Sprachen
System connections
Amplifier (General)
-E-
'c
©a
INE
MIDI system amplifier
To power outlet
Be sure to connect the power cord to a
SWITCHED AC OUTLET on the amplifier
(so that the memory functions are back-
ed up even when the power switch is
turned OFF).
Connections
Connecting to TAPE jacks of the amplifier
To use the tape jacks, connect between the line input jacks
(LINE IN) of the graphic equalizer and the tape record jacks
(TAPE REC OUT) of your amplifier. Connect between the line
output jacks (LINE OUT) of the graphic equalizer and the tape
playback jacks (TAPE PLAY IN) of your amplifier with RCA
pin-plug cords. Take care not to mistake the left L and right
R_ channels.
Connecting to MIDI system amplifier
Connect the LINE IN jacks of this unit to the ADAPTOR OUT
jacks of the amplifier and connect the LINE OUT jacks to the
ADAPTOR
IN jacks with RCA pin-plug cords. Take are not to
mistake the left [E] and right [R] channels.
Tape decks
Connect between the tape record jacks (TAPE REC OUT) of
the graphic equalizer and the record input jacks (REC IN) of
your tape deck. And connect between the tape play back jack
(TAPE PLAY IN) of the graphic equalizer and the play back
output jacks (PLAY OUT) of your tape deck with RCA pin-plug
cords. Take care not to mistake the left [L] and right [R]-chan-
nels.
G GE-810 (U)
For Europe
AC outlet (UNSWITCHED) (Except for some areas)
This outlet provides power when the unit is plugged into an
active AC wall outlet, regardless of the setting of the POWER
switch. Its total maximum capacity is 200 watts.
Precautions
1. Before connecting or disconnecting any cord, be sure to
turn off the power
switches
of the unit and pre-main
amplifier.
2. Each audio cord must be connected securely to the cor-
responding terminals ( [[] to
and [R] to [R}).
3. Do not bind the input/output cords with the power cord
and speaker cord. Do not extend the input/output cords
unnecessarily to avoid the possibility of noise or deteriora-
tion of tone qualitiy.
SYSTEM CONTROL jacks
These jacks are used for synchro recording. Using the syn-
chro
cords
with
miniplugs,
connect
these
jacks
to the
SYSTEM CONTROL jacks of the amplifier and cassette deck.
Werbung
