Philips AquaTrio Cordless 7000 Serie Bedienungsanleitung Seite 28

English
28
Problem
I cannot remove the
microfiber brushes.
I cannot move the appliance
forward or backward.
The appliance has a lower
suction power than usual.
The microfiber brushes do
not turn anymore
The microfiber brushes pop
out.
The appliance is not
charging.
Possible cause
Water leaks from the clean
water tank because you
overfilled the clean water tank.
There is a crack in one of the
tanks.
Hair and/or dirt is entangled in
the microfiber brushes.
One or more wheels may be
blocked by a small object.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The mesh in the dirty water
tank was not dry enough
before being used again.
Hair entanglement on the
microfiber brushes.
The dirty water tank is not
placed correctly.
The microfiber brushes are
clogged with hair or dirt.
The microfiber brushes are not
locked correctly.
The power plug is not
connected properly to the
socket or the adapter is not
inserted into the wall socket
properly.
Wrong adapter connected.
Solution
Do not fill the clean water tank beyond the
MAX indication. If you do, water may spill
from the clean water tank when you fasten
the cap.
If one of the tanks is damaged, take it to a
Philips service center or contact the
Consumer Care Center.
Use the cleaning brush handle to remove
the microfiber brushes from the AquaSpin
nozzle. Remove entangled hair or dirt. If it
is difficult to pull the brushes out, you can
give them a push from below the AquaSpin
nozzle.
Switch off the appliance and remove the
nozzle. Then check the small and the big
wheels for blockage. Remove any object
that could block the wheel(s). Put the
appliance upright again and resume
cleaning.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the appliance').
Clean and dry the dirty water tank.
Switch the appliance off and remove the
hair from the microfiber brushes.
Place the dirty water tank into the
appliance properly. It is closed correctly
when you can hear a 'click' sound.
Clean the microfiber brushes with a pair of
scissors or by hand.
Place the microfiber brushes back in the
right position and lock them.
Make sure that the power plug is
connected properly to the socket and that
the adapter is inserted into the wall socket
properly.
Please use the original adapter.
If you have checked the above and the
appliance still does not charge, take it to a