Inhaltsverzeichnis
Werbung
7. Move the upper blade of the grass blades so that the middle
line of the plastic ring is positioned exactly in the centre of the
hole.
8. Place the four locking holes of the grass blades onto the four
locking pins on the gear carriage. Make sure that the cam of
the gear wheel completely snaps into the plastic ring.
9. Warning! Do NOT operate the switch before the blade cover
is installed. Risk of injury!
Turning ON and OFF
Before switching on the grass and
hedge shears make sure the safety
disabling device (5) is inserted in
place.
1. To turn the grass and hedge
shear on, press the safety switch
(4) and then press the ON/OFF
switch (3).
2. To turn off the grass and hedge shear, release the ON/OFF
switch.
3. Use less pressure when trimming. Do not force the shear
while trimming. Use common sense while working.
Do to carry the grass and hedge shear with the fingers on the
safety switch and on the ON/OFF switch.
Using the Wheel Assy (Optional)
1. Press the wheel assy in the
grass and hedge shear until
the assy locks audible. On
both sides of the housing
you will find two notches.
Make sure the wheel assy
locks in these notches.
Operation
24
8
Werbung
Inhaltsverzeichnis
