Inhaltsverzeichnis
Housing's Bottom - Gehäuseunterteil
8
Housing's Top - Gehäuseoberteil
10
Housing's Top, IP65 - Gehäuseoberteil, IP65
13
Windshield, XT - Windschutz, XT 350-8517
21
Windshield 180, XB - Windschutz 180, XB 350-8518
23
Windshield 260, XB - Windschutz 260, XB 350-8519
25
Windshield Easy - Windschutz Einfach 320-8504
27
Twin-Reference Weight Device - Zwei-Referenzgewichts-Modul 320-7140
28
Mechanism Without Reference Weights - Mechanismus ohne Referenzgewichte
28
Single Reference Weight Device - Ein-Referenzgewichts-Modul 320-8021
30
Mechanism Without Reference Weight - Mechanismus ohne Referenzgewicht
30
.......................................................................................................... 32
Electronics - Elektronik
32
Main Board, New Vers. - Hauptprint, Neue Ausf. 320-7215-020/021
33
Main Board, Old Version - Hauptprint, Alte Ausführung 320-7200-020/021
33
Connector Board - Steckerprint 320-7232-010
34
Connector Board - Steckerprint 320-7203-010
34
Display Board VFD - Displayprint VFD 320-7204-010
35
Display Board LCD - Displayprint LCD 320-7207-010
35
Universal Switching Power Adapter - Universal-Schaltnetzteil 350-8384
36
Universal Switching Power Adapter IP65 - Universal-Schaltnetzteil IP65 320-8025
36
Twin Reference Weight Version
37
Before You Get Started
38
General Procedure for Opening an XT/XB Balance
41
General Procedure for Opening an IP65 Balance
41
Removing the Weighing Cell from the Housing's Bottom
42
Dismantling the Weighing Cell
43
Installing New Horizontal Flexures
45
Assembling the Weighing Cell
47
Installing the Weighing Cell into the Housing's Bottom
52
Single Reference Weight Version
53
Before You Get Started
54
Removing the Reference Weight Device (SCS Only)
58
Removing the Weighing Cell from the Housing's Bottom
58
Dismantling the Weighing Cell
59
Installing New Horizontal Flexures
61
Assembling the Weighing Cell
63
Installing the Weighing Cell into the Housing's Bottom
68
Installing the Reference Weight Device into the Housing's Bottom (SCS Only)
68
Before You Get Started
70
Setting the Balance to the Factory Mode (the Balance Is Open)
70
Adjusting the Symmetry
71
Adjusting the Corner Load
71
Checking the Lowering Process of the Internal Reference Weight (SCS Only)
74
Setting the Balance to the Service Mode (the Balance Is Closed)
75
Adjusting the Linearity
76
Checking the Adjustments of the Closed Balance
78
Adjusting the S-Correction
79
Adjusting the Internal Reference Weight (SCS Only)
81
Discussion with the Manufacturer
83
