ASROCK A780FullDisplayPort Bedienungsanleitung Seite 32

All manuals and user guides at all-guides.com
2 . 1 1 2 . 1 1 2 . 1 1 2 . 1 1 Serial A 2 . 1 1 Serial A Serial A Serial A Serial AT T T T T A (SA A (SAT T T T T A) / Serial A A (SA A (SA A (SA
Installation Installation Installation
Installation Installation
This motherboard adopts AMD SB700 south bridge chipset that supports Serial ATA
(SATA) / Serial ATAII (SATAII) hard disks and RAID (RAID 0, RAID 1, RAID 10 and
JBOD) functions. You may install SATA / SATAII hard disks on this motherboard for
internal storage devices. This section will guide you to install the SATA / SATAII hard
disks.
STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard
disk.
If you plan to use RAID 0 or RAID 1 function, you need to install at least 2
SATA / SATAII hard disks. If you plan to use RAID 10 function, you need to
install 4 SATA / SATAII hard disks.
2.12 Hot Plug and Hot Swap F 2.12 Hot Plug and Hot Swap F 2.12 Hot Plug and Hot Swap Functions for SA 2.12 Hot Plug and Hot Swap F 2.12 Hot Plug and Hot Swap F
HDDs HDDs HDDs
HDDs HDDs
This motherboard supports Hot Plug and Hot Swap functions for SATA / SATAII Devices
in RAID / AHCI mode. AMD SB700 south bridge chipset provides hardware support for
Advanced Host controller Interface (AHCI), a new programming interface for SATA host
controllers developed thru a joint industry effort. AHCI also provides usability enhancements
such as Hot Plug.
NOTE
What is Hot Plug Function?
If the SATA / SATAII HDDs are NOT set for RAID configuration, it is
called "Hot Plug" for the action to insert and remove the SATA / SATAII
HDDs while the system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has
been installed into the SATA / SATAII HDD.
What is Hot Swap Function?
If SATA / SATAII HDDs are built as RAID 1 then it is called "Hot Swap"
for the action to insert and remove the SATA / SATAII HDDs while the
system is still power-on and in working condition.
3 2 3 2 3 2
3 2 3 2
ASRock
A) / Serial A A) / Serial A A) / Serial A A) / Serial AT T T T T AII (SA AII (SA AII (SA AII (SAT T T T T AII) Hard Disks AII (SA AII) Hard Disks AII) Hard Disks AII) Hard Disks AII) Hard Disks
unctions for SAT T T T T A / SA unctions for SA unctions for SA unctions for SA
A780FullDisplayPort Motherboard
A / SA A / SA A / SAT T T T T AII A / SA AII AII AII AII