Specifications; Extension Cords - Still RME 339.0 Gebrauchsanleitung

18 Specifications

Fault
The grass has not
been cut cleanly or
the lawn is yellow.
18 Specifications
18.1 Lawn Mower
STIHL RME 339.0
– Power supply: See rating plate
– Frequency: See rating plate
– Power input: 1200 W
– Weight (m) with grass catcher box: 14 kg
– GB country-specific version:
Weight (m) with connection cable and grass
catcher box: 15 kg
– Maximum grass catcher box capacity: 40 l
– Working width: 37 cm
– Speed (n): 3200 rpm
– Electrical protection class: II
– Electrical type of protection: IPX4
18.2 Blade
– Minimum thickness a: 1.6 mm
– Maximum grinding limit b: 5 mm
– Sharpening angle c: 30°
18.3

Extension Cords

If an extension cord is used, it must have a
ground wire and the wire gage of its conductors
must meet the following minimum requirements –
depending on the line voltage and length of the
extension cord:
If rated voltage on the rating label is 220V to
240V:
– Cord length up to 20 m: AWG 15 / 1.5 mm²
– Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
0478-121-9925-A
Cause
The blade is blunt or worn.
The resistance at the blade is too
great.
Remedy
► Sharpen and balance the blade,
15.3.
► Set a higher cutting height,
► Mow shorter grass.
If rated voltage on the rating label is 100 V to
127 V:
– Cord length up to 10 m: AWG 14 / 2.0 mm²
– Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
18.4 Sound Values and Vibration
Values
The K value for the sound pressure level is
1 dB(A). The K value for the sound power level is
0.9 dB(A). The K value for the vibration value is
0.6 m/s².
– Sound pressure level L
ance with EN IEC 62841-4-3: 79 dB(A)
– Guaranteed sound power level L
ured in accordance with 2000/14/
EC / S.I. 2001/1701: 93 dB(A)
– Vibration value a
hv
with EN IEC 62841-4-3, handlebar: 1.20 m/s²
The indicated vibration values were measured in
accordance with a standardised test method and
can be used for the purpose of comparing electri‐
cal appliances. The actual vibration values that
occur may deviate from the indicated values,
depending on the type of application. The indica‐
ted vibration values can be used for an initial
assessment of the vibration load. The actual
vibration load must be assessed. Times during
which the electrical appliance is switched off,
along with times during which it is switched on
but running without load, can also be taken into
consideration.
For information on compliance with Employers'
Vibration Directive 2002/44/EC and
S.I. 2005/1093, see www.stihl.com/vib.
18.5 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
English
measured in accord‐
pA
meas‐
WAd
measured in accordance
10.2.
37