Installation; Planning Layout And Preparation; Installing And Connecting The Charging Station; Connecting The Power Supply - GreenWorks Optimow 10 Bedienungshandbuch

Installation

EN
Read the entire section before beginning installation. Installation affects mower capability.
Plan the installation carefully.
The following are the main tasks within the installation:
•

Planning layout and preparation

•

Installing and connecting the charging station

•

Connecting the power supply

•

Initial charging of the battery

•

Installing the boundary wire

• Installing the guide wire
•

Calibrating and initial start up

PLANNING LAYOUT AND PREPARATION

Ensure that the following conditions exist in the operating area where the mower will be used:
•
The grass is shorter than 10 cm.
• There are no stones, loose pieces of wood, wire, live mains cables, and other foreign objects.
•
The operating area is even and has no ditches, grooves, and steep slopes greater than 35%.
The following tools are required for installation, but not included:
•
Hammer/rubber mallet to drive the pegs into the ground
•
Combination pliers to cut the boundary wire
• Polygrip to press the couplers together
•
Hex key, 6 mm for securing the charging station to ground
8
GREENWORKSTOOLS.EU