Bernstein FlexM03 Montageanleitung Seite 5

FlexM03
DRAINING
• 30 l / min. with strainer
• 40 l / min. without strainer
• sealing water height is 39 mm
• certified according to EN1253-2015
• Stainless steel 304
• Robust ABS siphon
• Outlet as DN 40
• Standard width is 3 cm
• Installation height is 72 mm
• Can be tiled up to 12 mm height
ASSEMBLY
1. Before installing the shower drain, remove the drain cover to avoid scratching. The edge of the shower channel can
be protected on the top with tape to secure it.
2. Make sure that no impurities get into the siphon during installation, walling and tiling. We recommend sealing it
during the work.
3. Connect the drain to the waste pipe pushing the reduce-piece 40mm as far as possible over the 40mm pipe
of the drain (the rubber washer ensures a waterproof connection) and the other side (50mm) to the waste-pipe,
using glue.
4. Determine the position of the shower channel and drill dowel holes. Attach support feet.
5. Height-adjust the channel on the support feet and align it horizontally.
6. Connect drain pipes with sufficient slope (approx. 1.5%).
7. Fill in the space under the drain and around it with cement mortal, taking notice of the thickness of the tiles.
8. When laying the tiles, make sure that the slope in the shower area is always in the direction of the shower drain.
Place the tiles at least 1 to 2 mm higher than the top of the drain to avoid water collecting along the drain.
9. After installation, seal the tiles to the drain with a silicone sealant according to the manufacturer's guidelines.
For best results, make sure the silicone joint is the same width as the joint between the tiles.
10. C arefully remove any cement or grout residue with a plastic wool/sponge.
11. Place the grid in the drain and remove the protective cover from the grid before using the bath.
The siphon can be rotated 360 °
Different shower channel designs
(slotted, perforated, tileable, etc.)
Various lengths available.
5