Extension For Multiple Aggregates; Description; Installation - Mandik VULCAN Montageanleitung, Inbetriebnahme Und Gebrauchsanweisung

EXTENSION FOR MULTIPLE AGGREGATES

1 Switch AUTO/VYP/MANUAL
2 Switch HEATING/VENTILATION
3 Indicator light MANUAL
4 Indicator light AUTO
5 Indicator light ERROR

Description

The MMS+OMM3 (OMM6) control box is used
to control up to three (six) MONZUN gas air
heaters in one temperature zone.
The device allows for each unit to switch be-
tween control using the MMS thermostat (e.g.
according to the weekly program) or manual-
ly (in heating or cooling mode) or to turn off

Installation

The OMM3 (OMM6) control box serves as an
extension of the MMS controller to control up
to three or six MONZUN aggregates. It is in-
tended exclusively for indoor use.
5
4
1
Fig. 3: Description of the OMM3(OMM6) control box
®
MANDÍK, a. s., Dobříšská 550, 267 24 Hostomice | www.mandik.cz
3
2
the device. A fault condition is reflected both
on the MONZUN heater by lighting up the red
Fault light, and also on the control box by the
ERROR light for the given unit.
On the left side is the HEAT/COOL switch used
to switch between these modes in manual
control.
Mount the control box using the enclosed
dowels and screws in the selected location.
Bring the cables through the grommets on
the bottom or the holes in the back wall of the
cabinet and connect according to Fig. 4.
EN
23
|