Viewing Of Setting; Using Of The Transitional Timer (Party Button); Control Elements Lock; Process Of Regulation Parameters Setting - Mandik VULCAN Montageanleitung, Inbetriebnahme Und Gebrauchsanweisung

Viewing of setting

1. Push twice the programming button
(middle one) in order to enter in time block
setting, this symbol shows
2. Turn the wheel to subsequently view all
8 time blocks.

Using of the transitional timer (party button)

The transitional timer is used to temporary pro-
long the comfort or attenuation mode under
extraordinary presence/absence.
Room thermostat in the automatic operation
mode .

Control elements lock

Push and keep the right button for 3 s to lock or unlock control elements.

Process of regulation parameters setting

1. Push the left and the right buttons togeth-
er for 4 s at least.
2. Release the buttons and immediately push
the right button and keep for about 3 s un-
til P01 is shown instead of the temperature
on the display.
3. Turn the wheel to choose the requested
parameter.
3. Press the button Esc
.
Push the left button for max. 3 s and at the
same time turn the when clockwise to prolong
the comfort mode, display
anticlockwise to prolong the economy mode,
display
be set by 9:30 hrs max, following the expira-
tion of the set time the regulator returns back
to the standard operation according to the
time program.
4. Push the right button ok
5. Push the right button ok
In order to set further parameters, repeat steps
3 to 5, in order to leave the parameter setting
mode push Esc button
®
MANDÍK, a. s., Dobříšská 550, 267 24 Hostomice | www.mandik.cz
standard operation.
0 -9:30. Both prolongation can
chosen parameter starts blinking, you can
change it by turning the wheel.
set value, using Esc value
change.
to return to the
0 +9:30 or
, the value of
to confirm the
you cancel the
.
|
EN
21