Setting Of The Rdg 160 T Room Thermostat; Current Time And Week Day Setting; Time Program Setting (Change) - Mandik VULCAN Montageanleitung, Inbetriebnahme Und Gebrauchsanweisung

SETTING OF THE RDG 160 T ROOM
EN
THERMOSTAT

Current time and week day setting

Press the button of time program setting
(middle one), the display shows the symbol
, confirm with the right button
bers showing the time start blinking, turn the
wheel and set the current time.
In order to change the time display format
from 24 hours format to the 12 hours one and
vice versa override the value 23:59, i.e. 00:00,
when setting the time.

Time program setting (change)

The room thermostat includes 8 programma-
ble time blocks that can be assigned to one or
more week days.
1. Push twice the programming button
(middle one) in order to enter in time block
setting, this symbol shows
2. Turn the wheel to choose the time block
A1...A8 you wish to set and confirm with
right button
3. Turn the wheel and set the comfort mode
start
button
4. Turn the wheel to set the end of the com-
fort = start of the attenuation mode
and confirm with right button
20
|
.
.
and confirm with the right
.
Confirm the set time with right button
the week day indicator starts blinking, set the cur-
. Num- rent day by turning the wheel anticlockwise.
Confirm the set day with right button
the left button, the symbol
by pressing the left button you exit the pro-
gramming mode.
Note.: In case of power supply breach the time
starts blinking to indicate the power supply
failure. The time program continues with origi-
nal time before the power supply failure.
5. Symbols of week day 1, ok
starts blinking. Push the button ok
order to insert or Esc
time block in that day.
6. As soon as the block is/is not inserted into
the seventh day, all chosen week days start
blinking. Confirm the setting by the button
ok
another time block.
In order to save your setting do not forget to
push ok following the step 6 before you press
the button Esc to exit the programming mode.
.
VULCAN REGULATOR | Instalation, operation instractions and maintenance manual
not to insert the
and thus you pass to setting of
,
. Above
(Esc), is shown,
and Esc
in