Replacing The Batteries - Hama TH-130 Bedienungsanleitung

4.2. Replacing the batteries

• Pull the battery compartment out by
the notch.
• Remove the spent battery and insert
a new CR2025 button cell, observing
polarity.
• Gently push the battery compartment
back into the housing until it clicks
into place.
5. Installation
• You can either stand the thermometer/
hygrometer on an even surface using the
fold-out stand on the back of the device,
or attach it to a wall using the opening
on the back of the device.
• Install an anchor, screw, nail, etc. in the
wall of your choice.
• Hang up the thermometer/hygrometer
by the notch.
Warning
Before mounting, check that the wall you
have chosen is suitable for the weight
to be mounted Also make sure that
there are no electric, water, gas or other
lines running through the wall at the
mounting site.
6. Operation
• After inserting a battery, all of the
segments of the display will ash brie y.
• The thermometer/hygrometer is now
ready for use.
• After calibration, the top half of the
display shows the measured temperature
value, while the bottom half of the
display shows the measured air humidity
value.
4
• If the measured value is outside of the
measuring range, LL.L (value lower
than minimum) or HH.H (value higher
than maximum) will appear on the
temperature display.
• Once the elements on the display begin
to dim, replace the batteries as described
in 4. Getting Started.
6.1. Celsius / Fahrenheit
• Press the °C/°F button to switch between
°C and °F for the temperature display.
6.2. Maximum and minimum
temperature and humidity values
• The thermometer/hygrometer
automatically stores the maximum and
minimum temperature and humidity
values.
• Repeatedly press the MAX/MIN
button to switch between the current
temperature and humidity, minimum
temperature and humidity (MIN) and
maximum temperature and humidity
(MAX).
• The maximum and minimum values are
automatically deleted every 24 hours.
6.3. Comfort display
The thermometer/hygrometer displays the
following comfort ranges based on the ratio
between the current room temperature and
room humidity: