ATOMSTACK M150 Bedienungsanleitung Seite 2

Part 1 : Security Statment and warning
Before Using the laser engraving, please read this safety guide carefully, it mentions situations that
require special attention and includes warnings of unsafe practices that can cause damage to your
property or even endanger your personal safety.
1. This product is a laser engraver system components, must be installed in other manufacturers of laser engraver for use.And the
product belongs to Class 4 laser products, the laser system itself must meet the requirements of IEC 60825-1 latest version, other-
wise the product is prohibited to be used.
2. Your laser engraver shall have a protective housing which, when in place, prevents human access to laser radiation.
3. If a protective housing is equipped with an access panel which provides "walk-in" access then:
a) means shall be provided so that any person inside the protective housing can prevent activation of a laser hazard that is equiva-
lent to Class 3B or Class 4.
b）a warning device shall be situated so as to provide adequate warning of emission of laser radiation equivalent to Class 3R in the
wavelength range below 400 nm and above 700 nm, or of laser radiation equivalent to Class 3B or Class 4 to any person who
might be within the protective housing.
c) where "walk-in" access during operation is intended or reasonably foreseeable, emission of laser radiation that is equivalent to
Class 3B or Class 4 while someone is present inside the protective housing of a Class 1, Class 2, or Class 3R product shall be
prevented by engineering means. NOTE Methods to prevent human access to radiation when persons are inside the protective
housing can include pressure sensitive floor mats, infrared detectors, etc.
01