Costway NP11010 Bedienungsanleitung Seite 5

INSTALLATION
1. Provide an area that is free of any sharp objects with at least 6
hours of full sunlight a day.
2. Allow the collectors to relax in the sun (30 minutes to an hour).
DO NOT LAY COLLECTORS ON THE GRASS AS IT CAN
DAMAGE THE LAWN UNDERNEATH! DO NOT WALK ON
COLLECTORS.
3.Join the heating pipes together using one black rubber
connector hose and two 2" hose clamps. Position 2" hose clamp
in from each end of rubber connector hose and tighten (as
shown). Do Not Overtighten. Do not push connector hose against
tubes of collector.
4.Cover the rubber end caps on the ends of the heating pipe with
a 2" hose clamps. Position 2" hose clamps and tighten (as
shown).
5.Cover the rubber elbows on the other ends of the heating pipe
with a 2" hose clamps. Position 2" hose clamps and tighten (as
shown).
6.1 If connect to the soft hose, insert the D32-38mm hose adapter
the rubber elbow. Position 2.5" hose clamps and tighten (as
shown).
6.2 If connect to D50mm pvc pipe, do not install the D32-38mm
hose adapter to the rubber elbow. You can connect to the pvc
pipe directly. Then position 2.5" hose clamps and tighten (as
shown).
7.Turn off the pool pump.
8.Go to pool and plug the round return fitting on the pool wall from
the inside so the water won't drain through (a winter plug works
well).
08
9.Connect a hose from the filter to the lower elbow connector.
Always fill the system from the bottom.
10.Connect the other hose from pool return fitting to the other
elbow connector.
11.From the inside of the pool wall, remove the plug you placed in
the round return fitting.
3 4
6.1 6.2
.
YOU ARE NOW READY TO START-UP YOUR SOLAR
POOL HEATER
12.Turn on the pump. Check for leaks and tighten the connections
that need attention.
Note:Upon start-up you will see air bubbles come through the
return hose.
This is normal and will stop after all the air has been purged from
the solar heating system.
5
09