System Layout - Costway NP11010 Bedienungsanleitung

CAUTION:
a) Solar collectors are often installed on the roofs of buildings.
Unless you are very familiar with working on roofs and have the
proper ladders and safety equipment for such work, you should
hire someone with the necessary experience to do the
installation. Failure to observe safe practices on a roof or other
elevatedstructure may result in falling, leading to serious injury to
you.
b) When installing collectors on the ground, do not build a rack
support that could allow children access into the pool.
IMPORTANT
READ THIS ENTIRE MANUAL BEFORE
STARTING ORIENTATION
Components
Item Description
1 Solar collector
2 Rubber end cap
3 2" stainless steel hose clamp 27-51
4 2.5" stainless steel hose clamp 33-57
5 Rubber connector hose
6 Rubber elbow connector
7 D32-38mm hose adapter
8 Manual
06

SYSTEM LAYOUT

Required:
● Screwdriver
● To install your solar heating system, you will require 2 hoses -
one that will reach from the pool equipment to the collector and
one that reaches from the collector back to the pool.
Rubber End Cap
Qty
2
2
10
2
2
Rubber
Elbow
2
2
1
1
3
2 4 5 6 7
Rubber elbow
Rubber End Cap
Cool Water
(Feed)
Warm Water
(Return Fitting)
(Above Ground Pool)
Pool Pump Filter
07