Dmx-512 Connection / Connection Between Fixtures; Master/Slave Operation - EuroLite 16 DMX Bedienungsanleitung

Do not operate this device with opened cover plate!

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120 resistor
between Signal (–) and Signal (+) in the DMX-output of the last fixture.
Note: This device is designed for vertical connections.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear of the device you can find a 3-pin XLR connector for DMX-input and a 3-pin XLR plug for DMX-
output, which can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set DIP Switch 10 to 0 in order to determine the Master device, then choose the desired mode. (see
OPERATION)
20/26 00049912.DOC, Version 1.1