Product Introduction - 2N Telekomunikace EasyGate IP Bedienungsanleitung

EN

Product Introduction

2N® EasyGate IP is a gateway designed for voice transmission via VoIP (or VoLTE/GSM/UMTS) with cloud supervision.
The 2N® EasyGate IP package includes the following:
2N® EasyGate IP
DIN rail bracket (wall)
Dowels (6 mm) with screws (4.5 x 40 mm)
Screw for device fixing in bracket
Antenna
Power supply cable
FXS cable
Power supply
Brief Manual
NiMH type AA, 1.2 V / 2100 mAh battery
2-pin and 3-pin terminal
Connector
Layout and Meanings
FXS Analog line
NO (Normally Open), contact that is open against the COM contact at relax.
RELAY COM, contact that switches between NO and NC after voltage is applied to the coil.
NC (Normally Closed), contact that is connected with the COM contact at relax.
INPUT Shorting input. Not used for voltage connection.
Used for connecting the device with the serial bus (in some controller types, e.g.).
TX, output from 2N® EasyGate IP.
RS232
RX, input to 2N® EasyGate IP.
GND, grounding.
RESET A short press restarts the device. A long press (20 s) resets the device factory values.
USB Used for local access to the 2N® EasyGate IP settings via the Web configuration utility.
SIM 1 Primary SIM card slot without PIN.
SMA Antenna connector.
SIM 2 Secondary SIM card slot for primary SIM backup at signal loss.
POWER Power supply connector.
Connector for remote connection of 4 external NiMH batteries outside the device. Power is
EXT
withdrawn from the external battery automatically in the case of an electrical power failure.
Make sure that the internal batteries are removed from the device before connecting external
BATT
batteries!
O/I Device on/off switch.
2
1 pc
1 pc
2 + 2 pcs
1 pc
1 pc
1 pc
1 pc
1 pc
1 pc
4 pcs
1 + 1 pc