Herschel Inspire CL-200 Installations & Bedienungsanleitung Seite 4

When placed in public areas, installation must comply with relevant local electrical standards. For certain
public buildings like schools and care homes the heaters must be installed according to the specific
legislation for these types of buildings.
The electrical supply to the unit should be provided by connecting to a circuit protected by a fuse or residual
current device (RCD) or Ground Fault circuit interrupter (GFCI ) suitable for the electrical rating of the
appliance. Temperature control must be effected by a Thermostat.
Colour coding used in the supplied mains cable: BROWN wire is to be connected to LIVE ('L'), the BLUE wire
to NEUTRAL ('N') and the GREEN/YELLOW wire to EARTH ('E').
CAUTION:
• Ensure mains power is OFF before commencing an installation involving fixed wiring.
Any fixed wiring outside the heater coming into contact or close proximity to the heater must be
•
protected by sleeving with a temperature rating of at least 90°c.
• All cabling behind the appliance must take the shortest route to the edge of the heater.
• Ensure that the power cable is not coiled. Shorten the power cable if possible and do not place excess
cable on the rear of the heater.
Electrical connections must not be made behind the heater regardless of wall or ceiling-mounting
•
position.
• The heater is not to be located immediately below a socket outlet in either wall or ceiling-mounted
positions.
DO NOT
drill through the heater as this will cause irreparable damage and is also dangerous.
•
DO NOT
• connect a heater that is damaged in any manner to the power network.
When ceiling mounting use the narrower slide-in channel in the brackets supplied.
When wall or ceiling mounting ensure that the adjustable spacing feet in the corners are screwed out until
a slight pressure is established between the panel and the mounting surface.
For mounting the Herschel panel use the supplied mounting hardware only and install in accordance with
the installation guide. Herschel Infrared Ltd cannot accept responsibility for damage, loss or injury caused
by, or resulting from incorrectly installed heaters. Herschel Infrared Ltd will not assume liability for
consequential loss however caused.
MAINTENANCE AND REPAIR:
The Herschel panel must be installed, uninstalled, cleaned or transported only when cold.
CLEANING:
Before attempting to clean the panel, unplug the heater, isolate the unit from the electrical supply and allow
it to completely cool down.
DO NOT
immerse the Herschel panel heater in water or splash water onto it.
Clean the heater with a damp cloth . For glass models glass cleaner can be used. Never use a wet cloth.
When clean, dry the surfaces with a dry cloth.
DO NOT
apply abrasive materials, solvents or solvent wipes to the surface as this can cause irreparable
damage.
Wait until the unit is completely dry before use.
ENGLISH