Herunterladen Inhalt Inhalt Diese Seite drucken

Important Safety Precautions - Herschel Inspire CL-200 Installations & Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17

IMPORTANT SAFETY PRECAUTIONS

READ THESE INSTRUCTIONS CAREFULLY AND RETAIN FOR FUTURE
REFERENCE.
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1.
This appliance must be disconnected from its power source during installation or service activities and
when replacing.
2.
The INSPIRE is not equipped with an integrated device to control the room temperature. If intended
for use in an enclosed space for the purposes of room heating, Herschel iQ controls must be used. If
you do not fit a room temperature controller,
occupied by people incapable of leaving the room on their own, unless constant supervision is
provided. Herschel is not responsible for any breach of EcoDesign or Safety legislation where the
heaters are used in an enclosed space without use of a Herschel iQ controller.
3.
In order to avoid overheating and potential fire hazard,
material or similar material under any circumstances.
flammable materials (eg. Furniture, curtains).
DO NOT
4.
touch the heater when in use. Herschel panel heaters have a surface temperature of around
95°C / 248°F and prolonged contact with the heater will cause burns and injury.
DO NOT
5.
operate the heater if the cord or plug is damaged or after the heater malfunctions, or if it
has been dropped or damaged in any manner. Check each heater for damage before installation. Make
sure that the heater itself, the plug and the cable are free of any visible signs of damage. The supply
cord cannot be replaced. If the cord is damaged the appliance must be scrapped in accordance with
the local Waste Electrical Equipment regulations.
6.
GLASS & MIRROR PANEL MODELS. Handle carefully and avoid stressing the glass mechanically. Do not
use the heater if the glass panels are damaged. Disconnect the heater and do not put it into operation
again. Dismount the heater immediately to reduce the danger of direct impact from falling pieces and
dispose of the unit in accordance with the local Waste Electrical Equipment regulations.
7.
This heater must only be used for the heating of people or buildings. The heater is not to be used by
children or persons with reduced physical, sensory or mental capabilities, or lack of experience or
knowledge. Children should be kept away and should not be left unsupervised around the unit.
8.
All operators should only switch on/off the appliance provided that it has been placed or installed in
its intended operating position in accordance with these instructions. Children must not plug in, switch
on or regulate the appliance or perform user maintenance including cleaning.
IMPORTANT:
9.
Hz AC. If your supply voltage exceeds 240 Volts do not use the heater and refer to your local dealer.
IMPORTANT:
10.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50
The heater must be mounted on a non-flammable surface.
DO NOT
use for room heating when rooms are
DO NOT
cover the heater with insulating
DO NOT
locate the heater within 0.3m of any
ENGLISH

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis