Yealink ETV65 Schnellstartanleitung Seite 6

4
Install wall-mounted bracket (b) on the back of the endpoint
Tear the patch and remove the screws on the
back of the endpoint
1
B
X 4
（M8*35mm） （φ32）
Put the rubber gasket on the back of endpoint, in-
stall the wall bracket (b) and lock the screws and
gaskets
X 4
We recommended that the screw
be installed to the third hole of the
wall-mounted bracket (b)
If the installation height is slight-
ly inappropriate, you can adjust
the installation hole position to
meet your needs.
4
2