Control Panel; Positioning The Appliance - MO-EL 9006 Bedienungsanleitung

CONTROL PANEL

The thermostat has certain default parameters which can be modified via the con-
trol panel.
To access it, press and hold the Menu and Up buttons simultaneously while the
display is off.
Press the Menu button again to scroll through the following settings:
01) Temperature calibration: If the temperature readout on the display differs from
the actual ambient temperature, it can be calibrated by increasing or decreasing it
0.5°C at a time, up to a maximum of 8°C. The default value is 0.
02) T.Max: Maximum temperature which can be set. Ranges from 5°C to 80°C.
03) T.Min: Minimum temperature which can be set. Ranges from 5°C to 80°C.
04) Hysteresis: Temperature interval beyond which the thermostat activates.
A range of between 0 and 3°C can be selected.
05) Frost protection: Temperature at which the heating system connected to the
thermostat will be turned on to prevent freezing. It can be set to between 5°C and
15°C, or deactivated by selecting the position - -.
06) Restore settings: Press the Up or Down buttons; 88 will appear on the display.
Wait until the device exits the settings menu. All settings will be returned to their
defaults and any programming performed will be lost.
07) Open window function: The device is fitted with a lock system to stop the
heating in the event of a sudden fall in temperature, due presumably to an open
window or similar. Select 1 to activate this system, or 0 to deactivate it.
08) Open window detection time: Detection time in which the drop in temperature
will activate the open window lock function. Choose between 2 and 30 minutes.
09) Open window temperature drop: Temperature drop in degrees centigrade,
within the detection time, required to activate the open window lock function.
Select a value between 2°C and 4°C.
10) Return to normal operation: This setting determines how long the appliance
should wait before returning to normal operation after activation of the lock func-
tion. Select a value between 10 and 60 minutes.
11) Software Version
12) Software Version 2

POSITIONING THE APPLIANCE

The unit is composed of two parts:
- The thermostat with digital display, which incorporates the electronics, the op-
erational elements and the integrated room temperature sensor. (fig.1-2)
- The receiver to be attached to the wall with the terminals for the electrical con-
nections. (fig.3)
As regards the thermostat, this can either be positioned on a horizontal surface
simply by placing it on its support, which will keep it slightly tilted in order to facili-
tate reading (Fig.1), or else attached to the wall via the corresponding plate, which
should be attached to the wall with screws through the holes, before attaching the
module to it by engaging the 4 pins (Fig.2).
11