Ip Address Configuration; Technical Data - MO-EL 9006 Bedienungsanleitung

Fig.1
The receiver is opened, on the other hand, by releasing the two pins on the base,
and once the electrical connections have been made it should be fastened to the
wall with two screws in the corresponding holes.

IP address configuration

The thermostat and receiver have a unique code which connects them and allows
them to communicate.
This connection is usually already set; if it is not, proceed as follows:
1. Press the identification button on the receiver; the green LED will start flash-
ing.
2. Shut off the thermostat, press and hold the menu button for 3 seconds. The
board will beep, and the LED on the receiver will stop flashing.
3. The channel will be shown on the thermostat display; press the menu button
again.
The thermostat and receiver are now connected.

TECHNICAL DATA

Thermostat Supply Voltage
Backup Memory
Receiver current
Frequency
Channel selection
Switching options
Receiver switch contacts
Temperature settings
Accuracy
Thermostat size
Receiver size
Colour
IP protection rating
Certification
Fig.2
2 x 1.5V AAA batteries
EEPROM
16 A
868MHz
By programming the thermostat and the receiver
Four periods per day, 5+1+1 days
NO and NC
5°C - 30°C, 0.5°C increments
+/- 0.5°C (+/- 1°F)
135x88x22 mm
114x86x30 mm
White
20
CE
12
Fig.3