Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Manual
Pay attention
- Please note that the charging port of the device should not have water
infiltration. Otherwise, it will cause a product failure.
- Do not charge or store the product in a place below 0°C or above 40°C,
otherwise the product performance will be reduced.
- It is a normal phenomenon that temperature of the adapter rises during
charge use.
Security and important safety instructions
Class III equipment: This is a class III device and can only be used with low
voltage power, connection only to SELV power-circuits.
When using electrical products, certain precautions must be followed,
including the following:
- This product is suitable for indoor use and it's not waterproof IP-6X, do not
submerse under water!
- Please use the rated input voltage power supply of the product as
mentioned on the back label.
- Do not install near a gas device or other sources with a similar heating
process.
- Do not use the product outside its intended use.
- Read and follow all instructions that are indicated on the product or
supplied with it.
- Keep this manual for future reference.
Instructions for use and maintenance
In case of non-use, store the product in a cool and dry place away from
direct sunlight.
Caution: NON-Replaceable LED lights!
Note:
- Use with caution at all times.
- Product specifications are subject to change without notice.
- If disassemble the device without authorization, we cannot guarantee
the quality.
Cleaning the device
- Make sure the device is kept dust free and clean. Clean it regularly with a
dry anti-static lint free cloth and dry the device before turning it ON again.
- Please do not immerse the main unit in water, it is not waterproof!
- Wipe gently with a clean soft cloth (microfiber) dampened with water or
a mild detergent.
- Do not use a strong aggressive/irritant lotion such as gasoline, alcohol,
cleaning agents or rubber water.
Troubleshooting
Display does not turn on or is abnormal and/of function is not
working?
- Try to power on/off and use max brightness by the brightness knob on the
back itself. Or RESET if needed as described in this manual.
Memory loss function? The battery is sufficient?
- Check the CR battery control built-in and replace if needed. Or remove the
old battery by pressing the tab on the side of the battery cover and slide
of the cover from the back of the clock. Take notice of the positive (+) and
negative (-) side of the battery, make sure that the new battery (CR2032
3V) is inserted the right way. Slide the cover back on and dispose of the
old battery responsibly.
Note: Remove the batteries from the product if it is not used for a long
time (1 month or longer).
Waste electrical & electronic equipment
Batteries and rechargeable batteries do not belong in the household waste!
You are required by law to dispose of used batteries and rechargeable
batteries to a collection point in your municipality or city administration
or to a specialist battery dealer so please return the battery/device to the
collection point which will dispose of the device and/or battery properly.
If te battery is built-in inside the product , open the product and remove
the battery!
Separate collection
This crossed out wheelie bin symbol means the product must not be
discarded with the general household waste. There is a separate collection
FlinQ Wireless QI Clock
Werbung
Inhaltsverzeichnis
