Fixing The Finishing Frame; Warranty - STRATOS STR6000 Installationshandbuch

Place the fuse-holder and fuse kit (50 A) supplied on the positive pole.
Place the 1 A fuse supplied on the positive pole of the battery signal cable.
Provide a 50A DC magneto-thermal switch on the line, if the vehicle does not have one.
It is highly recommended not to extend the cables supplied with extension cables as this could alter
the battery protection intervention threshold of the appliance, causing premature blocking of the
appliance. Once the connections have been made and the cables are properly fixed, insert the male
connector of the wiring into the female connector of the air conditioner, making sure that the
connection is secure. Before proceeding, check the electrical connection, starting the air conditioner
from the control panel. Make sure that the air conditioner has started and keep it running for a few
minutes.
Check that the nominal battery voltage corresponds to the nominal data
of the air conditioner shown on the product label.
In the event that an extension of the power cables is required, or other
modifications (additional connectors, etc.), contact customer support.
Respect the polarity

4.7 Fixing the finishing frame

Mount the finishing frame taking care not to invert the front with the back. Refer to the illustrations.
The external profile of the finishing frame is identical to that of the original frame of the hatch.
Position the spacers indicated in the table (position no.7) and tighten the M6 screws in the original
fixing seats together with the indicated washers and tighten them until the frame adheres to the
upholstery of the vehicle roof. In case of misalignments between the screw seats and the holes in
the frame, slightly widen the holes in the frame.
Be careful not to overtighten the screws to avoid damaging the frame.

5 WARRANTY

The warranty lapses in the event of appliance faults resulting from installations that do not comply
with this document and/or which have been performed by unqualified personnel.
The Manufacturer declines all responsibility for damage caused to the vehicle or to persons
deriving from installations that do not comply with this document and/or which have been
performed by unqualified personnel.
EN
16