What To Do If The Alarm Sounds - ELRO FC280211 Bedienungsanleitung

3.8 Fault warning silence
When the device is in a fault state, press the TEST/SILENCE button, it will enter the fault warning mute state for about
9 hours, while displaying "
NOTE: The silence feature of fault warning is a temporary action to cancel warning sound effect, you need replace
the device as soon as possible.
3.9 End-of-life warning
If the device chirps 3 times every 40 seconds with FAULT indicator (yellow) flash and the LCD displays 'End'. It
indicates end of life of CO alarm. You need to immediately replace the CO alarm.
3.10 End-of-life warning silence
When the device is in the End-of-life state, press the TEST/SILENCE button, it will enter the End-of-life warning mute
state for about 9 hours, while displaying "
NOTE: The silence feature of fault warning is a temporary action to cancel warning sound effect, you need replace
the device as soon as possible.
3.11 Test the device
When the device under normal operation status, you can test the device by TEST/SILENCE button, PRESS and HOLD
the TEST/SILENCE button, you should hear alarm sound pattern (<85dB) and with a corresponding ALARM indicator
(red) flash. After the eighth sound, the device will issuing a normal alarm volume (≥85dB). Test process will stop
when release the button. The LCD displays all segments during testing.
NOTE: After the TEST/SILENCE button is enabled, the alarm sounds and the red alarm light flashes. This does not
indicate that CO is present.
NOTE: Test the device every year! If at any time your device does not perform as described, replace it immediately.
3.12 Automatic brightness adjustment
Automatic brightness adjustment of POWER indicator (green). If the ambient brightness is very low (night, indoor &
lights off). The flashing brightness of the POWER indicator (green) will be reduced, to reduce the impact of the
standby indicator light on people.
NOTE: This function does not affect the brightness of the ALARM indicator (red) and the FAULT indicator (yellow).
3.13 Weekly test
Recommend test the alarm weekly by pressing the TEST/SILENCE button to ensure the normal operation of the
equipment.
3.14 Alarm memory
48 hours alarm memory function. When the device detects CO and alarms, when the device returns to standby
mode, and the CO concentration <20PPM, LCD displays "AL" and ALARM indicator (red) flash per 40 seconds. After
press TEST/SILENCE button or after 48 hours, will reset the historical memory function and enter normal operation
status.
4.

WHAT TO DO IF THE ALARM SOUNDS

WARNING! Actuation of your CO alarm indicates the presence of Carbon Monoxide (CO) which can KILL YOU.
4.1 Keep calm and open all doors and windows to increase the rate of ventilation. Stop using all fuel-burning appliances
and ensure, if possible, that they are turned off, e.g., for gas appliances, isolate the emergency control valve.
4.2 If the alarm continues to be activated, then evacuate the premises. Leave the doors and windows open, and only
reenter the building when the alarm has stopped. In multioccupancy and multi-story premises, ensure that all the
occupants are alerted to the risk.
4.3 Get medical help for anyone suffering the effects of carbon monoxide poisoning and advise that carbon monoxide
inhalation is suspected.
4.4 Telephone the appropriate appliance servicing and/or maintenance agency or, when necessary, the relevant fuel
supplier on their emergency number or the national Gas Emergency Service Provider, if appropriate, so that the
source of carbon monoxide emissions can be identified and corrected. Unless the reason for the alarm is obviously
spurious, do not use the fuel-burning appliances again, until they have been checked and cleared for use by a
competent person according to national regulations.
" on the LCD, and the FAULT indicator (yellow) remains flashing.
" on the LCD, and the FAULT indicator (yellow) remains flashing.
- 4 -