Safety Advice - NTools PWW 400 Betriebs- Und Wartungsanleitung

Ridges
Pull the lever (10) and gradually open the regulator (8) so as to obtain ridges of the
desired consistency.
Partial measurements and paintwork
Various partial measurements may be obtained by slightly opening the regulator (9). If the
regulator is opened further, finishes with various grain may be obtained as required.
IMPORTANT
Do not work with the gun without the cartridge, you could damaged the piston !
IMPORTANT
Please read these instructions carefully to ensure the safe and effective use of this tool.

SAFETY ADVICE

Never direct a jet of air at people or animals. Do not point this gun at any other person.
Always wear eye protection. Take advice from the manufacturer of the material you are
spraying with this product and wear an appropriate face mask, use skin protection. Do not
spray when other people are in the vicinity and do not allow children anywhere near your
spraying equipment. Check the air pressure you are using is suitable for the product and
the material to be sprayed and do not connect the airlines until you are absolutely ready to
commence work. Check the air pressure is no more than 10 bar (140 Psi). Do not spray in
enclosed areas and maintain good ventilation.
CAUTION
Take off the cartridge after use even if it is not empty. Keep inner nozzle (pos. 21 - white
colour) and outer nozzle (pos. 19-20 black colour) always clean. Before using the gun
ensure that cured sealant is not blocking the nozzle orifice. If cured sealant is blocking the
nozzles do not remove them until they have been
both cleaned by cured sealant with heavy gauge
wire and until the product starts flowing out of the
nozzles. A blocking nozzle can cause a dangerous
situation even if the gun is not connected to the
compressed air.
12