Derby cycle Xion SMMI Connect Kurzanleitung Seite 5

The sMMI is compatible with the bracket docks of the first series as
well as with the new bracket docks. The remote control with three
buttons (figure 3) is permanently installed/wired on the handlebar
dock. The retaining pin on the new bracket dock (figure 2) is used
to better secure the sMMI, but you can also safely attach the sMMI
to the bracket dock of the old series (figure 4).
ATTACHMENT AND DETACHMENT OF THE SMMI
Attachment (01)
Place the sMMI (figure 5.1) on the dock at an angle of about 30
degrees to the left (figure 5.2). While applying slight pressure, turn
the sMMI (figure 5.1) on the dock 30 degrees clockwise so that
both components are aligned (figure 5.3). Be sure to avoid putting
the sMMI on in the wrong direction.
Detachment (02)
Before detachment, the sMMI must be switched off.
Turn the docked sMMI (figure 5.1) by 30 degrees counterclockwise.
The electrical connections are detached in the process and the
sMMI (figure 5.1) can be removed.
Bild 5: Auf-/Abnehmen des sMMI
Figure 5: Attaching/detaching
the sMMI
(Bild 5.3)
(Bild 5.1)
(Bild 5.2)
5