Using Pressure Vessels; Intended Use; Operation And Commissioning; Before Commissioning - STIER LKT 880-10-90 Originalbetriebsanleitung

EN User Guide
• Do not spray against the wind. Always comply
with the regulations of the local police
authority when spraying combustible or
dangerous materials.
4.5

Using pressure vessels

• Anyone who uses a pressure vessel must keep
it in good condition, operate it properly,
monitor it, carry
maintenance and repair work immediately and
take the appropriate safety measures required
by the circumstances.
• The
supervisory
necessary monitoring measures in individual
cases.
4.6

Intended use

• The
compressor
compressed air for pneumatic tools.
• The machine must only be used for its
intended purpose. Any other use beyond this is
considered contrary to the intended use. The
user/operator, and not the manufacturer, is
5

Operation and commissioning

5.1

Before commissioning

CAUTION
Before connecting the device, make sure that the
data on the nameplate corresponds to the mains
data.
Check the device for transport damage. Report
any damage immediately to the transport
company that delivered the compressor.
Install the compressor close to the consumer.
Avoid long air lines and long supply lines
(extension cables).
Ensure that the intake air is dry and free of
dust.
Do not install the compressor in a damp or wet
room.
The compressor must only be operated in
suitable rooms (well-ventilated,
STIER Industrial GmbH
out any necessary
authority may order
is used to generate
ambient
• Do not process any substances such as white
spirit, butyl alcohol or methylene chloride in
combination with the PVC pressure hose.
These substances will destroy the pressure
hose.
• A pressure vessel must not be operated if it has
defects that would endanger employees or
third parties.
• Check the pressure vessel for rust and damage
each time before using it. The compressor
must not be used with a damaged or rusty
pressure vessel. If you find any damage,
please contact
workshop.
liable for any damage or injury caused as a
result.
• Please be aware that our devices were not
designed for commercial, trade or industrial
use. We do not assume any warranty if the
device is used in commercial, trade or
industrial companies or in equivalent activities.
temperature +5°C to 40°C). There must be no
dust, acids, vapours or explosive or flammable
gases in the room.
The compressor is suitable for use in dry
rooms. The device must not be used in areas
where spraying water is being used.
Check the oil level before commissioning. The
oil level should cover at least half of the small
middle circle (red) and at most the full circle. If
the oil is milky, the oil must be changed to
prevent damage to the motor.
Only operate the device on firm, level ground.
Supply hoses at pressures above 7 bar should
be equipped with a safety cable (e.g. a wire
cable).
• Check electrical components and ensure they
have been correctly connected to the mains.
21
the customer service
EN