AutoFull AF083 Installationsanleitung Seite 8

07
Buckle up the cover of the recliner adjuster as shown and fix it
with the recliner adjuster screws
09
Lifting switch
Unscrew the pre-installed screws of the armrest surface, then fix the armrest surface and
the armrest handle with them
（note: the thick side of the armrest surface is on the same side as the handle lift switch）
5 13
08
Unscrew the pre-installed screws of the tilt mechanism, put on the tilt mechanism as
shown, and fix it with the tilt mechanism screws
（Note: After all the screws are screwed in 1/3, then tighten them all; after installation, the operating lever is
on the right side of the cushion when a person sits on the chair）
10
Unscrew the pre-installed screws of the armrest on the seat cushion, place
the armrest as shown, and fix it with the armrest screws
11
Unscrew the pre-installed screws of the footrest slider, place the footrest
slider as shown, and screw on the footrest slider screws
（Note: Do not tighten the four screws completely）
13
Insert the footrest back into the cushion, and put rubber bands on the top
of the sliding rod
12
Insert the footrest into the footrest slider hole.Swipe it back and forth
several times
（Note: When the sliding is not jammed, tighten all the footrest slider screws）
14
Insert the assembled base and cylinder into the hole of
the tilt mechanism
14