EN
1. Press the synchronising button.
2. Press the ring button. The status light flashes blue. The
programmed audio signal is heard and the status light goes off.
3. If the receiver does not indicate the received signal as
above, press the synchronising button again to activate the
synchronising function and repeat the synchronising process.
4. The status light on the transmitter flashes briefly to show that a
signal has been sent to the receiver.
SOUND SETTINGS
The receiver can indicate received signals optically, acoustically, or
both optically and acoustically.
•
Press the signal button to specify whether the signal is to be
indicated optically, acoustically, or both optically and acoustically.
VOLUME
Press the volume button to set the required volume. There are 5
volume settings, from almost silent to very high volume.
AUDIO SIGNAL
1. Press the melody button to browse through the audio signals.
The last selected audio signal is stored automatically.
2. Continue pressing the melody button to browse through the
different melodies.
3. The last selected melody is saved automatically.
MAINTENANCE
•
Do not use cleaning detergents to clean the door bell.
•
Clean the door bell by wiping it with a soft cloth.
TROUBLESHOOTING
The door bell can be affected by ambient conditions, e.g. strong
electromagnetic fields or the discharge of static electricity. If this
happens, remove the batteries from both the transmitter and
receiver for about 2 minutes. Insert the batteries again and repeat
42
the process for synchronising the transmitter and receiver.