Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13.
Battery compartment
14.
Holder (for wall mounting)
FIG. 2
INSTALLATION
NOTE:
•
A drill and screwdriver are needed for the installation.
•
Only use the supplied screws and plugs for the installation.
15.
Screw
16.
Plug
17.
Screw (for transmitter)
FIG. 3
BATTERY
Receiver
1. Open the battery cover on the back of the door bell.
2. Remove any old batteries.
3. Insert 2 x 1.5 AA batteries with the correct polarity as shown by
the markings in the battery compartment.
4. Replace the battery cover.
Transmitter
1. Remove the holder on the back of the transmitter.
2. Open the battery compartment by turning the battery cover
anticlockwise.
3. Insert 1 x3 V CR 2032 batteries. The side marked + should point
upwards.
4. Replace the battery cover and lock in place by turning it clockwise.
5. Remove the holder on the back of the transmitter.
USE
SYNCHRONISING
EN
41
Werbung
