Red Sea ReefATO+ Bedienungsanleitung Seite 19

Firmware Updates
From time to time, you may receive a notification that a new firmware
version is available for your device. It is important to keep your device
firmware updated to ensure compatibility with updates to the ReefBeat
App.
Individual units can be updated: Device manager > Device line menu >
Firmware Update.
To update all units simultaneously: Device manager > Device type menu
> Firmware update
Do not unplug a device while it is downloading and installing the new
firmware.
Device Manager > Device Line menu > About - will show the currently
installed firmware version. When the firmware update is complete, the
"About" page will show the new version as the current version along
with the date and time that the update was performed. All your previous
settings will remain as before. If the firmware update is not successful,
the device will automatically revert to the previous version. Repeat the
process a few minutes later.
If your device does not seem to be performing correctly after the update,
reboot the unit by pressing the settings button for less than 2 seconds.
Deleting a device
To remove a device from an aquarium, delete the unit from the ReefBeat
App:
Device Manager > Device Line menu > Delete.
Deleting the device before it is switched off will prevent unnecessary
notifications that it is disconnected from the cloud.
Clear settings
To permanently remove all user settings from the memory of the
ReefMat and return it to its initial default state, perform the following
steps.
If the device is connected to the ReefBeat, trigger the hard-reset option
from the Device-Manager: Device Manager> Device line menu > Hard-
Reset
If the device is not connected to the ReefBeat, press the Settings button
for about 15 seconds (until the Wi-Fi indicator LED shows a double blink),
release the button and wait for about 1 minute for the device to reboot.
The unit will restart without any user settings and with the Wi-Fi
switched on, exactly as shipped from the factory. The unit will retain the
latest installed version of the firmware.
Red Sea ReefATO+
ENG
19