Max STORM 6 Benutzerhandbuch Seite 9

plate shows the switch location. Putting the stencil plate in place, fix it with
tape.
4. Drill holes in the stencil plate corners. The holes diameter is 1-2mm.
5. Remove the stencil plate and connect the resulting holes with lines following
the pattern on the stencil plate.
6. Expand the holes with a drill of a larger diameter (6-7mm).
7. Using a fretsaw, cut a hole in the tabletop that follows the shape contours on
the stencil plate. Remove dust from the tabletop.
8. Insert the dust collector into the cutout hole, holding the dust collector by
the side edges of the cover. To do this, you need to make a pendulum
movement: insert one part, move the dust collector sideward, insert the
second part.
9. Draw out the dust collector from the tabletop. Degrease the dust collector
installation site.
10. Carefully peel off the protective layer of the double-sided adhesive tape
from the cover bottom. For additional fixation of the dust collector at this
stage, you can gently apply glue to the lower part of the top cover instead of
nails (not included in the kit).
11. Install the dust collector carefully. Try not to allow the adhesive tape to stick
before the moment the dust collector is installed in the designated place.
12. Gently press down on the top cover to fix its final position. When using glue,
let it dry according to the recommendations of the glue manufacturer.
13. Install the filter bag onto the air duct (see details in the «Use» section). Close
it with the locking plate.
14. Install the air duct. The lower outlet pipe, after its installation, can rotate
around its axis (with the application of force). This means that it can be
turned around as appropriate.
Usage
1. Install the filter bag on the fan. Do it carefully. The bag must be put on the
entire surface of the fan. Before using, spread the filter bag evenly.
2. Make sure that the filter bag is fixed evenly and not jammed.
3. Before switching on, make sure that there are no foreign objects between
fan blades.
4. Insert the plug into the 220V electrical mains. Use the switch located on the
wire to turn it on and off.
5. After the first switching on, it is recommended to lift the dust collector and
make sure that the bag is puffed and nothing disrupts the air flow.
6. Work in the area of the dust collector fan impeller approximately 1.5 cm away
from the edge of the grill to the center.
ENG
9