Herunterladen Diese Seite drucken

Etac Molift UnoSling StandUp Bedienungsanleitung Seite 5

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
Sling checkpoint
Checkpoint
Troubleshooting
1 The sling does
Wrong sling size. Try other size.
not fit the user.
The sling is not correctly positioned.
Reposition the sling.
2 The sling is
The user is not leaning backwards. Make the
sliding up to the
user lean backwards when lifting.
user's armpits.
The waist belt is loose. Tighten the waist belt
properly.
The user is not able to take load on their legs/
feet. Evaluate whether a sit-to-stand hoist is
right or if the user requires a passive hoist.
3 User is sliding
The lifting straps are not fastened correctly.
through/out of
Make sure both lifting straps are equal in length.
the sling.
The sling is too big. Try a different size.
The user is not leaning backwards. Make the
user lean backwards when lifting.
The waist belt is loose. Tighten the waist belt
properly.
The user is wearing slippery clothes. Change or
remove some of the clothing.
The user is not able to weight bear on their legs/
feet. Evaluate whether a sit-to-stand hoist is
right or if the user requires a passive hoist.
Lifting checkpoints
1 Check that the sling is correctly fitted around the user and that the
lifting loops are correctly fitted to the sling bar hooks.
2 Make sure the user has both feet placed firmly on the footplate on
the hoist and the strap on the leg support is properly fastened around
the user's leg.
3 Start lifting until the lifting straps are stretched without lifting the
user. Ensure that both loops of the sling are securely fastened to avoid
the user slipping or falling out of the sling.
4 Make sure the buckle is properly fastened
5 Lift the user to standing position. Tighten and adjust the waist belt if
necessary.
Sling application – Sitting position
1 Ask the user to lean forward, support them if necessary with one
hand. Slide the sling down behind the user's back. Place the sling
approximately at waist height on the back. Use the center marking to
ensure the sling is placed aligned with the user's spine.
2 Place the belt around the waist of the user, connect the buckle and tigh-
ten the belt.
3 Place the hoist in position for fastening the sling to the sling bar.
Place the user's feet on the footplate and fasten the strap on the leg
support around the user's leg.
4 Make sure the lifting straps are fastened with equal length on right
and left side.
5 The user must lean back slightly when being lifted, and if possible
hold onto the handles. The waist belt should be retightened when
lifting begins and when the sling is loaded.
1
3
5
Sittting position – Removing the sling
1 Lower the user into a sitting position. Release the lifting straps from
the sling bar. Remove the hoist, and unlock the waist belt buckle.
2 Stand next to the chair and ask the user to lean forward. Support
the user with one hand if necessary. Pull the sling away with one
hand, and ask the user to lean back in the chair.
1
Molift UnoSling / www.etac.com
2
4
2
5

Werbung

loading