AmazonBasics B07GFCKTWG Bedienungsanleitung Seite 5

Registering Fingerprints (Maximum
storage of 50 fingerprints)
• To register your fingerprint, locate the "Reset" button (5).
a. Press and hold the reset button until you hear two beeps and the buttons flash blue twice.
b. Press your finger on the biometric scanner. Remove your finger when you hear two beeps
and see two blue flashes.
c. Now your fingerprint has been successfully registered.
d. If the buttons flash red 5 times with 5 beeps, it means registration has failed and you must
repeat the above steps.
• Note: You cannot register more than 50 fingerprints. If the red light flashes 5 times with 5 beeps
when you press the reset button, it means the fingerprint storage capacity is full.
• Suggestion: To increase capture accuracy, register 3 or 4 times with different parts of the same
finger to ensure most areas of the finger are registered.
Registering the same finger at multiple positions.
Registration #1 - Centered and Vertical
Delete the Registered Fingerprint
1. Press and hold the reset button.
2. You will hear two beeps together with two blue flashes.
3. Keep the reset button depressed until you hear another two beeps with two blue flashes, then
release it.
4. Now all registered fingerprints are erased.
Registration #2 - Centered at an angle
5