Inhaltsverzeichnis
Werbung
1
Ready...let's start!
Before playing, an adult must install fresh alkaline batteries in the
Light-Up module (part C). Here's how:
Tool required (not included)
Battery installation MUST be
completed by an adult:
1. Using a Phillips screwdriver (not included) remove the screw
and battery compartment cover from the Light-Up module
(part C).
2. Install three (3) fresh 1.5V AA (LR6) alkaline batteries (not
included), making sure the (+) and (-) ends face the proper
direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screws.
2
It's time to add some lights
Turn the slide (part A) over to access the underside.
Place the Light-Up module (part C) onto the screw
bosses.
C
A
1.5V AA/LR03
1.5V AA/LR03
1.5V AA/LR03
(2)
/
" (1.27 cm)
1
2
Secure the light-up module using (2)
5
C
Modes
1. Combination
2. In Wave
3. Sequential
4. Slow Glow
5. Chasing/Flashing
6. Fade
7. Flash/Twinkle
8. Steady on
9. O
Modes
ON
OFF
/
" screws.
1
2
Werbung
Inhaltsverzeichnis
