Safety Instructions - Xblitz Master X Bedienungsanleitung

the first time, pair it with the selected device by activating BT connectivity on
the latter and select XBLITZ MASTER X from the list. Successful pairing will be
confirmed by an audible message from the speaker.
To switch to the next song, briefly press the + button. To switch to the
previous song, briefly press the - button. To increase or decrease the volume,
hold down the + button or the - button respectively. Briefly press the M
button to switch the unit to FM mode.
During a phone call, the announcer will read out the caller's phone number,
then start beeping the incoming call. Briefly press the POWER button to
answer the call or hold the same button to reject the call.
2. FM mode
To enter FM mode, briefly press the MODE button. For automatic pro-
gramming of radio stations, press the POWER button. The unit will scan
the frequencies in the broadcast band 87.5 - 108 MHz and store the radio
stations in scanning order. To switch between the preset radio stations,
briefly press the + or - button.
Note: To improve the quality of radio reception, it is recommended to plug
the supplied USB cable into the micro-USB port on the device.
3. AUX mode
Connect the speaker with another device using the AUX cable supplied.
The device will automatically switch to AUX mode. To switch the speaker to
another mode, use the MODE button or remove the AUX cable (the speaker
will then return to the default BT mode).
4. Playback from external storage media
The device plays .mp3 files from external storage media - USB flash drives
and micro-SD cards. To switch to the playback of .mp3 recordings, simply
place the selected storage medium in the corresponding slot on the loudspe-
aker. To switch between tracks, briefly press the + or - buttons. A short press
on the POWER button stops playback from the memory storage.
Note: to avoid the possibility of damaging the storage medium, it is recom-
mended to connect and disconnect it when the device is switched off.
5. LED backlighting
The device has several modes of LED backlighting. To switch between
modes, press the LED button briefly. To switch off the LED illumination, hold
down the button.

05. SAFETY INSTRUCTIONS

7