King gates JET Installierungs-Und Gebrauchsanleitungen Und Hinweise Seite 15

3. Brackets installation
scheme
1. Measure "E" and draw a horizontal line in the scheme at the
corresponding value.
2. Choose a point on the drawn line, considering the desired
opening angle. Draw a vertical line from that point and
determinate the A value.
3. Verify that the A value allows the fixing of the rear bracket
before continuing the installation, otherwise choose another
point on the scheme.
4. Finally, bring the piston to the limit position (FIG. 2) but
avoiding that the sliding pin touches the aluminum body.
FIG.1
FIG.2
All manuals and user guides at all-guides.com
CAUTION: If the installation measures are not properly
followed, the automation may not work correctly. For
example:
• Cyclical trends, and sudden accelerations
• Noise of the motor
• Limited opening degree or absent opening (in case of
motor counter-lever configuration)
OPENING
ANGLE
15