Commend GEC 880 Bedienungsanleitung Seite 10

English
Gong on client side
Button
c
3
 When the gong has been triggered, conversation is not possible (in none of the directions).
 If the gong is triggered during a conversation, the conversation is re-established when the gong has
ended.
Station parameters
Button
d
e
f
3
The following parameters can be set:
Parameter
ACK
LCD
LED
VCI
VEB
VEX
The selected parameters are saved automatically. Even when the power supply is disconnected the
selected parameters remain stored.
Acknowledgement tones
There are two types of acknowledgement tones:
 "Beep" = OK
 "Boing" = not available
When pressing the button
Bell tone from client side
For this function to work, there must be a bell button on the client side or a proximity switch, and the
station must be configured by a technician.
Situation
The client presses the bell button or enters
the client-side area (if a proximity switch is
used).
10
Function
Press to trigger a gong at the client-side loudspeaker(s) to attract the at-
tention of clients.
Press to end the gong immediately.
Function
Press to enter the user settings mode. Press the button again to cycle through the parame-
ters.
Press to decrease the value of the current parameter.
Press to increase the value of the current parameter.
Press to exit the parameter settings mode at any time.
The parameter settings mode automatically ends after 5 seconds of inactivity.
Description
Acknowledgement tones (keypad tones) on/off
Adjustment of LCD display contrast
Brightness of the LED (see "Day/night mode" on page
Volume level for playback of tone signals on the service side
(keypad tone, ringtone and alarm tone)
Volume of client-side loudspeaker in BOOST mode
Volume of client-side loudspeaker
c 4
or , no acknowledgement tone is audible.
Function
A bell tone is audible (in HEADSET MODE at
both the service-side loudspeaker and the head-
set).
GEC 880 User Manual
Display
GONG
Value range
0.... OFF
1.... ON
1.... 10
9) 1.... 10
1.... 10
1.... 13
1.... 13
Display
BELL
2.0/0719