Kasanova HWK000006NOC Bedienungsanleitung Seite 18

WET & DRY HANDHELD VACUUM CLEANER
18
2. Select a suitable installation location for the wall mount (3): It should not
present any barriers to remove the hand vacuum cleaner from the wall mount
and it should be easily accessible to a mains power socket.
3. Make two holes with a distance of about 58mm. Use the wall mount (3) to
mark the boreholes. The boreholes must be suitable for 5 mm wall plugs.
4. Insert the wall plugs into the boreholes and, using the screws, firmly screw
the wall mount (3) to the wall.
5. You can place the nozzles on the lateral accessories holder.
6. Connect the power adapter 4() to a mains power socket.
CHARGING
Note:
Check to ensure that the on/off switch is in the "0" position "0" before starting
the charging process.
• Place the hand vacuum cleaner from above into the wall mount (3) so that
the barrel plug and the power cord (5) slips into the socket on the hand
vacuum cleaner.
The charge indicator lamp (7) glows Blinking RED and the charging
process begins.
IMPORTANT!
• • When the charging process is complete, which may take 6 to 8 hours
for completely discharged batteries, the device switches over to a trickle
charge automatically. Nevertheless, in order to avoid possible damage to
the batteries, do not leave the appliance permanently connected to the
power adapter.
• • Reconnect the appliance with the power adapter when the suction power
has become noticeably weaker
NOTE:
The hand vacuum cleaner can also be charged directly via the power adapter
(4). For this, remove the barrel plug and the cord (5) with a slight twist from the
wall mount (3) and insert it into the socket on the hand vacuum cleaner.
OPERATION
Warning!