conecto CC50686 Bedienungsanleitung Seite 13

REVERSING THE CONNECTION (1 CHANNEL)
1. Use the respective OFF button (A, B, C or D) on the remote control to turn off the wireless
socket.
2. Remove the wireless socket in question from the socket.
3. Re-insert the wireless socket into the socket.
4. Now press the OFF button for the same channel, while the red LED flashes. The red LED
now flashes faster, to signal the cancelled connection.
The wireless socket can be assigned to another channel immediately, by pressing
any ON button.
REVERSING THE CONNECTION (ALL CHANNELS)
1. Use the ALL-OFF button on the remote control to turn off the wireless socket.
2. Remove the wireless socket in question from the socket.
3. Now re-insert the wireless socket into the socket.
4. Now press the ALL-OFF button, while the red LED flashes. The red LED now flashes faster, to
signal the cancelled connection.
5. To assign new channels, the wireless socket has to be removed and re-inserted into the socket.
NOTES
• The wireless sockets are switched on and off using the remote control (ON/OFF button).
• When the buttons are activated, the red LED on the remote control illuminates briefly.
However, the red LED on the wireless socket remains illuminated for as long as it is
switched on.
• The range reduces if the signal has to pass through ceilings, doors, windows or walls
(environment dependent).
• The ON/OFF button in the "ALL" area can be used to switch all wireless sockets on or
off at the same time.
• Do not connect electrical consumers with a higher resistive load than 5A.
• Do not connect tungsten filament lamps which exceed a wattage of 100w.
• Do not connect electrical consumers with inductive loads containing motor capacitors
(such as refrigerators).
- 3 -